Canopy
Click picture to enlarge click again to enlarge
Sea Fury canopy fit & glued to frame with Poly-Zap
Canopy left
Canopy right
Poly-Zap dried & tape removed
Had to use CA glue to install windscreen
Canopy rear
Canopy open
Canopy & windscreen finished
Firgelli linear motion actuator used to open & close canopy
Note slot in the push-pull power rod
The rear center arm is connected to slot
Wing
The arm is held in place by Aeropoxy glue encased in a plastic bubble
Copyright © 2005-2022 Walt Carnes, All rights reserved.
E-mail me at:
walt.carnes@aol dot com
June 27, 2015