Rudder
Click picture to enlarge click again to enlarge
June 27, 2015
Rudder framewook glued in place with Aeropoxy
Rudder framwwork close-up
Center hinge added
Bottom hinge added to rudder framwor4k
Drilled hole in 4MM allen head bolt to hiold hinge rod
Rudder hinge rod sweat soldered to 4 mm Allen head bolt
Rod is installed from the bottom
Rudder hinge rod intalled from the bottop
Rudder ready for installation of the 4-40 Pull-Pull system
Rudder & tail wheel pull-pull wires installed
Rudder wire inside plastic tube while tail wheel wire is shown going to tail wheel tiller
Moki Engine
Rudder wire exiting fuselage
Copyright © 2005-2022 Walt Carnes, All rights reserved.
E-mail me at:
walt.carnes@aol dot com
 "1 Rudder framewook glued in place with Aeropoxy")
 "3 Bottom hinge added to rudder framwor4k")
 "2 Rudder framwwork close-up")
 "4 Center hinge added")
 "5 Drilled hole in 4MM allen head bolt to hiold hinge rod")
 "6 Rudder hinge rod sweat solodered to 4mm allen head bolt")
 "9 Rod is installed from the bottom")
 "8 Rudder ready for installarion of the 4-40 Pull-Pull wires")
 "7 Rudder hinge rod intalled from the bottop")
 "10 Rudder & tail wheel pull-pull wires instakked")
 "11 Rudder wire inside plastic tube while tail wheel wire is shown going to tiller")
 "12 Rudder wire exiting fuselage")
