|
After putting the fuselage & wing together a few times I decided to follow the advise of Wayne Siewert & add a hatch to the bottom of the wing. The hatch will be used to pull the servo wires & retract plastic tubing from the fuselage into the wing after they are connected together.
|
 "1 Wing as received1")
 "3 Ailerons, Flaps, & servo boxes must be cut from wing1")
 "5 Cover in place1")
 "7 Ready for aileron & flap installation1")
 "9 Installation complete1")
 "11 Testing flap & aileron operation1")
 "13 Fitting1")
 "15 Another view1")
 "2 Wing")
 "4 Aileron servo box1")
 "6 Flap servo ready to install1")
 "8 Finished with balsa & covered with fiber glass1")
 "10 Closer view1")
 "12 Wing tip must be fit & glued in place1")
 "14 Finished wing tip1")
 "16 Wing mounted & flaps are down1")
 "1 Mounting bracket1")
 "2 Servo & air control valve1")
 "3 Hatch cover with small earth magnets1")
 "4 Air tank & controls1")
 "5 Another view5")
 "6 Finished Hatch1")
 "7 Hatch is held in place by wing1")
 "1 Cutting out the bottom wing hatch")
 "2 Hatch ready to glue in place")
 "3 Hatch open & ready to use")
 "4 Looking at bottom wing hatch from the top of wing hatch")
 "5 Closed & ready to fly")
 "6 Oatey heat 9x12 protector covers wires & plastic tubing.")
 "7 Color coded wires & tubing to connect to fuselage")
 "1 Unfinished gear doors")
 "3 Unfinished wheel well")
 "5 Finished left wheel well")
 "7 Left main landing gear down note radiator air intake")
 "9 Gear strut door covered with Flight-Metal")
 "11 Testing main gear")
 "2 Finished gear doors")
 "4 Finished right wheel well")
 "6 Finished main landing gear")
 "8 Finished strut door")
 "10 Main gear doors closed")
 "12 Testing gear")
