Fuselage
Click picture to enlarge click again to enlarge
A lot of work to do inside the fuselage
Gluing aircraft grade plywood inside front of fuselage with Aeropoxy glue
Close-up
Pictures that came with the model show gas & smoke oil bottles used
Du-Bro fuel line barbs soldered in place & Tygon tubing installed & safety wired
Clamps removed & holes drilled
Without bottles
Du-Bro 50 oz. fuel tank ready to install
Enlarging hole for air tank
Robart # 192 large air tank & Du-Bro fuel tank installed
Side view of air & fuel tanks
Ignition module bracket
Constructed two brackets for two 4500 mAh 6V NiMH batteries
JR 4500 mAh 6V battery
Five brackets glued into top front of fuselane using Aeropoxy glue
Moki ignition module & four batteries installed
Rear of cockpit with hatch I added. Also the bottom of the rudder-tail wheel servo
Used Aeropoxy to glue in the assembly that holds the Robart air tank & Du-Bro 50 oz. fuel tank
Canopy
Ready to install in fuselage
Moki ignition module
Sponge rubber added to top of bracket
Constructed two brackets for 2700 mAh 6V NiMH batteries
Cockpit glued in place with Aeropoxy glue
Bottom of the cockpit ready for receiver & other electronics
Inside view of tail wheel assembly with servo wire on left & air cylinder tubing on the right
Copyright © 2005-2022 Walt Carnes, All rights reserved.
E-mail me at:
walt.carnes@aol dot com
June 27, 2015
According to The Weather Channel Control Tower, the weather conditions at the Hanger are:
 "1 A lot of work to do inside the fuselage")
 "2 Gluing aircraft grade plywood inside front of fuseage with Aeropoxy glue")
 "3 Close-up")
 "5 Pictures that came with the model show gas & smoke oil bottles used")
 "7 Du-Bro fuel line barbs soldered in place & Tygon tubing installed & saftey wired")
 "9 Enlarging hole for air tank")
 "4 Clamps removed & holes drilled")
 "6 Withiout bottles")
 "8 Ready to install")
 "10 Robart # 192 large air tank & Du-Bro fuel tank installed")
 "11 Side view of air & fuel tanks")
 "13 Ignition module bracket")
 "15 Constructed two brackets for two 4500 mAh 6V NiMH batteries")
 "17 JR 4500 mAh 6V battery")
 "19 Five brackets glued into top front of fuselane using Aeropoxy glue")
 "21 Moki ignition module & four batteries installed")
 "23 Rear of cockpit with hatch I added. Also the bottom of the rudder-tail wheel servo")
 "25 Used Aeropoxy to glue in the assembly that holds the Robart air tank & Du-Bro 50 oz. fuel tank")
 "12 Ready to install in fuselage")
 "14 Moki ignition module")
 "16 Sponge rubber added to top of bracket")
 "18 Constructed two brackets for 2700 mah 6V NiMH batteries")
 "20 Moki ignition module & four batteries installed1")
 "22 Cockpit glued in place with Aeropoxy glue")
 "24 Bottom of the cockpit ready for receiver & other electronics")
 "26 Inside view of tail wheel assembly with servo wire on left & air cyyinder tubing on the right")
